5 posts • Page 1 of 1
I am writing a program to report the true position and diameter of 101 holes. I just finished when I realized that I forgot to change the diameter tolerance from our standard +/- .003" to the +.002/-.000" that is needed for this part. Is there any way to fix this other than deleting and starting all over again?
Unfortunately no, we've added capabilities to batch edit DCC parameters recently. I have plans to do something similar for reporting. This will be in a release sometime in the future, until then you have to edit individually or redo the report items.
- Ryan Christopher
- Posts: 251
- Joined: Mon Jun 06, 2011 3:00 pm
- Location: Sumner Washington