True Position Tolerance Report

Post Reply
User avatar
nek9
Participant
Participant
Posts: 8
Joined: Fri Apr 17, 2020 9:40 am

True Position Tolerance Report

Post by nek9 » Thu Apr 30, 2020 7:45 am

is there away to change the report for True position tolerance? So on the report it shows Nominal for X and Y position. My question is it possible to show the actual X and Y position instead of the deviation? so for example instead of dX=.0003 dY= -.0010 is it possible to change the report settings to show dx= -7.1467 dY= -2.8010
You do not have the required permissions to view the files attached to this post.

User avatar
CrashN8
Site Admin
Site Admin
Posts: 524
Joined: Thu Feb 09, 2017 4:07 pm

Re: True Position Tolerance Report

Post by CrashN8 » Thu Apr 30, 2020 10:03 am

Turn off Coord and Coord Dev. Instead use the Feature Rpt option as shown below. Notice that Upper / Lower tolerance are suppressed by unchecking the "Show Location Tolerances" checkbox.

true_position.jpg
You do not have the required permissions to view the files attached to this post.

User avatar
nek9
Participant
Participant
Posts: 8
Joined: Fri Apr 17, 2020 9:40 am

Re: True Position Tolerance Report

Post by nek9 » Mon May 04, 2020 12:05 pm

thank you :D

Post Reply