CMM-Manager crash after change tool and component in UCC

Post Reply
ken60
Power User
Power User
Posts: 69
Joined: Fri Mar 21, 2014 12:32 pm

CMM-Manager crash after change tool and component in UCC

Post by ken60 » Thu Oct 10, 2019 5:29 pm

A tool was name incorrectly to it physical component so I try to change it by removed that assembly in both tool and component menu then create new one with a correct name but when I change tool in the rack CMM M doesn’t recognize tools so I restart both CMM M and UCC, at this point CMM M will start but crash when try to read in last used tool. Anyone know how to fix this ? Thanks in advance

User avatar
CrashN8
Site Admin
Site Admin
Posts: 394
Joined: Thu Feb 09, 2017 4:07 pm

Re: CMM-Manager crash after change tool and component in UCC

Post by CrashN8 » Fri Oct 11, 2019 9:06 am

What version of CMM-Manager and UCC Server. This depends a lot on whether Renishaw XPath is used to sync tools or not. If nothing else you should perform a manual I++ Sync after making these types of changes.

ken60
Power User
Power User
Posts: 69
Joined: Fri Mar 21, 2014 12:32 pm

Re: CMM-Manager crash after change tool and component in UCC

Post by ken60 » Fri Oct 11, 2019 3:37 pm

Thank you CrashN8, CMM M 3.7SP2 and UCC version UCCserver 53000R1.
Today I run CMM M 3.6 and it ran fine except it won't activate the Ref assy. (CMM M switch from other probe assy to Ref assy. without physical change Ref assy. in rack)...Also, when I mess around with probe assembly in UCC I accidental deleted Ref assy then build a new one

Post Reply