Measuring and printing HOA (Height Over All)

CMSJOE
User
User
Posts: 9
Joined: Mon Aug 05, 2019 10:03 am

Re: Measuring and printing HOA (Height Over All)

Post by CMSJOE » Fri Aug 16, 2019 8:15 am

Yes, I have done that with other measurements like circles, spheres, and cylinders. But if you look at the screen shot with the feature report open, the two points are listed, but not the distance between them. That is the issue I am having. The ZA information in the Blue area in the top picture is not showing up in the report on the second picture.

User avatar
medupriest
Moderator
Moderator
Posts: 411
Joined: Fri Mar 13, 2015 11:59 am

Re: Measuring and printing HOA (Height Over All)

Post by medupriest » Fri Aug 16, 2019 5:05 pm

Add a "report distance between" step in your program and select the two feature and the thing you want to report. Feature report is for more generic reporting. This can be done from the "report ribbon tab" and then you can see it in the "report database tab".

adding report steps to your program from the "report ribbon tab" is how you can construct your reports in your program.

If you are unsure what these are, you can also check the items by searching for them in the help documentation that is accessed by clicking the "?" in the upper right hand corner of the screen.

Post Reply