ABC Alignment

Topics applicable to newer version(s) of CMM-Manager (3.0+)
Post Reply
FialekJared2018
Regular User
Regular User
Posts: 16
Joined: Mon Sep 10, 2018 3:02 pm

ABC Alignment

Post by FialekJared2018 » Wed Jun 12, 2019 10:37 pm

Hey everyone, having some trouble with figuring out how to do this type of alignment on a cup like part.
Datum A would be a flatness feature, Datum B is the diameter of I.D. of part, and then Datum C is a round slot type feature.

What would be the best route of making this an alignment to then measure profiles of areas in this part. Attached is a photo of what the Datum's are. Datum A is the top of the part
IMG_1755.jpg
You do not have the required permissions to view the files attached to this post.

Post Reply