Use multiple faces for cylinder ??

Post Reply
eric14779
User
User
Posts: 14
Joined: Mon Nov 05, 2012 9:17 am

Use multiple faces for cylinder ??

Post by eric14779 » Tue May 28, 2019 3:30 pm

Can I select 2 faces from cad to create cylinder feature to measure ?

My part is hollow between the two cylinder faces that I want to create one big cyliner from

User avatar
CrashN8
Site Admin
Site Admin
Posts: 323
Joined: Thu Feb 09, 2017 4:07 pm

Re: Use multiple faces for cylinder ??

Post by CrashN8 » Tue May 28, 2019 5:02 pm

CAD teach 3D should do this immediately... Otherwise use CAD Teach 2D twice, once at top, then at bottom, then finally construct the cylinder. Can you send the CAD to me? You can delete other surfaces in model if it's sensitive data.

Post Reply