SHOP FLOOR LAUNCHER

Topics applicable to newer version(s) of CMM-Manager (3.0+)
Post Reply
User avatar
myork1967
Nikon
Nikon
Posts: 39
Joined: Wed Mar 14, 2012 10:29 pm
Location: Herrin, il
Contact:

SHOP FLOOR LAUNCHER

Post by myork1967 » Tue May 21, 2019 3:25 pm

i just noticed something about the shop floor launcher....here goes.

I am on a cmm with dual monitors. Once i setup the shop floor launcher, CMM Manager is on one monitor with the shop floor launcher on the 2nd.

Problem is that the operator still has access to CMM Manager and not limited just to working in the launcher.

Normally I am on a CMM with only 1 monitor and from viewing this I am assuming that the shop floor launcher sets over CMM manager and locks out the desktop so no one will have access to the main program.

My question is other than dragging CMM Manager to set behind the shop floor launcher on the main window, is there another way to keep the operators out of the main program while CMM manager is located on the 2nd monitor.

User avatar
CrashN8
Site Admin
Site Admin
Posts: 323
Joined: Thu Feb 09, 2017 4:07 pm

Re: SHOP FLOOR LAUNCHER

Post by CrashN8 » Tue May 21, 2019 4:37 pm

Change your primary monitor in WIndows... SFL is drawn over entire "Primary" monitor / display. Run CMM-Manager once on Primary monitor and then both should be displayed on same monitor indefinitely. Also, check the options in Preferences for General Permissions.

Post Reply