DCC Settings Reset

Post Reply
SDNPDG_Quality
User
User
Posts: 14
Joined: Mon May 08, 2017 1:58 pm

DCC Settings Reset

Post by SDNPDG_Quality » Wed Sep 13, 2017 8:37 am

Hello,

In the wake of Hurricane Irma, we had to disconnect our CMM's from the controllers and move all of our equipment to higher ground. Basically all of our equipment for the CMM's were disconnected. Upon Re-connecting all of our equipment, we found that all of our DCC settings had changed. We have two CMM's both running CMM Manager and both had the DCC settings changed. Although the settings on each machine were reset differently. We have had power outages and what not before but have never had the DCC settings be changed. Could this be because we completely unplugged the controllers and computer? If not what could cause this to happen? Is this going to be a problem going forward?

Thank you,

Seal Dynamics Quality Team

User avatar
CrashN8
Site Admin
Site Admin
Posts: 447
Joined: Thu Feb 09, 2017 4:07 pm

Re: DCC Settings Reset

Post by CrashN8 » Thu Nov 09, 2017 9:53 am

DCC Settings will reflect values from last opened Program / Project. Just open a previously saved Program, save it, close it, then open a new file and your DCC Settings should be restored.

Post Reply