I have question about printing report lines from program list.
For now i make measuring program which machine measure few features, and after that I have a few lines of retporting this features, then again few features.
The question is why machine stops when is go to lines of reporting, an then again go to measure part in lines of features. Is it posible to move machine all time witchout this 'pitstops' ?
I know i can modyfi program to looks like Feature-Report-Feature-Report-Feature, and cmm will no stop each time, but its difficult when You have program like 500-1000 lines.
The reason of this problem is machine stops for few seconds each time (10-20s) in amount of measuring parts like 200-300, starts to make a nice few hours.
1 post • Page 1 of 1