Nikon VMA / iNexiv can be offered with TP20 or TP200 touch probe along with Renishaw MCR20 Probe Rack. Traditionally TP200 is not compatible with MCR20 rack, however it is possible with iNexiv hardware to use this combination.
Just configure probe per usual and add MCR-20(-3) rack in Machine Setup. Calibrate MCR20 rack per usual... Before loading / storing probe(s) to / from rack, go to Probe Ribbon Tab>Rack>Configure and add a -5.7mm Offset to rack location as shown below.
Software topics related to Nikon iNexiv and Retrofit Camera
1 post • Page 1 of 1