Rotary Table Support

Discuss hardware / software options here
Post Reply
User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1094
Joined: Wed Feb 23, 2011 7:26 pm

Rotary Table Support

Post by US_Helpdesk » Wed Sep 03, 2014 12:56 pm

CMM-Manager currently supports rotary table on LK / Nikon and Sheffield SMP built in rotary table support.

The ATS - SMW RT series is also supported as an add-on rotary table using the Accusmart 55 controller connected by serial / RS-232. This setup would be supported on anyCMM-Manager DCC plug-n-play system.
I've migrated to a new user account, see my other posts here

enpalani
Power User
Power User
Posts: 79
Joined: Thu Aug 01, 2013 11:44 pm

Re: Rotary Table Support

Post by enpalani » Thu Sep 04, 2014 3:19 am

Built in means LK / Nikon and Sheffield make CMM with their own rotary table. Am i correct?

If we want to use RENISHAW - 4 AXIS - controller OR PANTEC - 4 AXIS - controller with CMM-M, is it any rotary table available?

User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1094
Joined: Wed Feb 23, 2011 7:26 pm

Re: Rotary Table Support

Post by US_Helpdesk » Thu Sep 04, 2014 1:39 pm

Not integrated in to their driver... It would have to be this third party table mentioned in the previous post.

Renishaw or Pantec would need to be developed...
I've migrated to a new user account, see my other posts here

Post Reply