UCC Fusion and softlimits problem

Post Reply
User avatar
Szymon
Nikon
Nikon
Posts: 3
Joined: Fri Jun 15, 2012 4:40 am
Location: Poland/Warsaw
Contact:

UCC Fusion and softlimits problem

Post by Szymon » Wed Jan 02, 2013 8:52 am

Hi,

I did some upgrade on an old zeiss c400 machine and I've tried to set soft limits in cmm manager 3.0. CMM Manager recognizes soft limits but it doesn't slow down the machine and doesn't stop it on limit that has been set.

Any ideas what can cause that ?

Regards
Szymon Kania

User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1087
Joined: Wed Feb 23, 2011 7:26 pm

Re: UCC Fusion and softlimits problem

Post by US_Helpdesk » Wed Jan 02, 2013 12:05 pm

You probably need to specify the machine limits in the Renishaw Machine Configuration file as well. See the Setup guide Section 2.2 (3) Copy the machine configuration file to the Driver directory of CMM-Manager

See the Install guide here - UCC-xxx / Fusion (DCC or Manual)

Note: The soft-limits setting in CMM-Manager / Machine Setup do not cause the machine to stop, this setting only provides a visual and audible alert when the limits are exceeded.
I've migrated to a new user account, see my other posts here

User avatar
Budi
Nikon
Nikon
Posts: 1
Joined: Fri Jan 19, 2018 7:40 pm

Re: UCC Fusion and softlimits problem

Post by Budi » Fri Jan 19, 2018 8:43 pm

Dear Sir,

I try to download the link you write above, but it is not possible. It said that I am not authorized. How can I download this file ? Because I need it in order to connect my UCC Fusion with CMM Manager ver 3.3

Post Reply