Page 1 of 1

Leitz / Sharpe32z / RC1 (DCC)

Posted: Wed Oct 24, 2012 10:27 am
by US_Helpdesk
Leitz
Default settings:
Controller Selection: Leitz
Com Port Settings: 9600, N, 8, 1
OR
TCP/IP: IP address in the range 80.128.0.X (e.g. 80.128.0.1 assuming controller is using address 80.128.0.2) - Port 2001
ProbeType - TP6

RC1
Default Settings:
Controller Selection: RC1
TCP/IP: IP - 100.0.0.1 / Port - 1234
ProbeType - TP2

IQ Configuration / Driver File
Location: C:\ProgramData\Nikon\CMM-Manager [current version]\Driver
Example for RC1:
CONTROLLER 1 // 0 Leitz 1 RC1
...
PRBTYP TP2 // probe type
...
USE_ETHERNET 0 // 0 = use serial, 1 = use ethernet
CMM_IPADDRESS 100.0.0.1 // Controller network IP address
CMM_PORT 1234 // Controller network port number
Controller Configuration File: No configuration file (i.e. downl.oad or syspar.asc) is used for Leitz controller, configuration is stored on controller.

Error Map: Error Map for Leitz protocol should be located in controller. If so, no error map file is required. Even so, it is recommended to search for the usual suspects (i.e. comp.dat or comp.asc) and check in previous client software to see if software / file based Error Map was used.

Note: The Sharpe32 and Sharpe32z (Leitz) jogbox can be the same. To identify one vs. the other refer here - viewtopic.php?f=11&t=929

Image
new_Leitz_jogbox.JPG

For iOS / Mobile device click here to download the PDF file.

It appears you don't have a PDF plugin for this browser... you can click here to download the PDF file.