Leitz / Sharpe32z / RC1 (DCC)

User avatar
Posts: 1088
Joined: Wed Feb 23, 2011 7:26 pm

Leitz / Sharpe32z / RC1 (DCC)

Post by US_Helpdesk » Wed Oct 24, 2012 10:27 am

Default settings:
Controller Selection: Leitz
Com Port Settings: 9600, N, 8, 1
TCP/IP: IP address in the range 80.128.0.X (e.g. assuming controller is using address - Port 2001
ProbeType - TP6

Default Settings:
Controller Selection: RC1
TCP/IP: IP - / Port - 1234
ProbeType - TP2

IQ Configuration / Driver File
Location: C:\ProgramData\Nikon\CMM-Manager [current version]\Driver
Example for RC1:
CONTROLLER 1 // 0 Leitz 1 RC1
PRBTYP TP2 // probe type
USE_ETHERNET 0 // 0 = use serial, 1 = use ethernet
CMM_IPADDRESS // Controller network IP address
CMM_PORT 1234 // Controller network port number
Controller Configuration File: No configuration file (i.e. downl.oad or syspar.asc) is used for Leitz controller, configuration is stored on controller.

Error Map: Error Map for Leitz protocol should be located in controller. If so, no error map file is required. Even so, it is recommended to search for the usual suspects (i.e. comp.dat or comp.asc) and check in previous client software to see if software / file based Error Map was used.

Note: The Sharpe32 and Sharpe32z (Leitz) jogbox can be the same. To identify one vs. the other refer here - viewtopic.php?f=11&t=929


For iOS / Mobile device click here to download the PDF file.

It appears you don't have a PDF plugin for this browser... you can click here to download the PDF file.

You do not have the required permissions to view the files attached to this post.
Last edited by CrashN8 on Mon Feb 04, 2019 11:38 am, edited 1 time in total.
Reason: updated content
I've migrated to a new user account, see my other posts here