Search found 34 matches
- Wed Jun 17, 2020 1:50 am
- Forum: General Application Support
- Topic: User defined dimension
- Replies: 5
- Views: 339
I'm confused about this. The red graphs are correct. In both cases you are at the tolerance limits, so the bar should show this as it does. .0001 more and you are out of tolerance.
Maybe I'm over simplifying this, or not understanding what the problem is. I would simply call up the cad model and perform my alignment with a four point plane where the datum targets are shown. Then align the part off the hole and slot, set my datum on the "XY" hole.
Old CMM's are great. nothing wrong with a Mititoyo BRM 507. As long as it's well taken care of and you have good software on it. Up until recently I used an old Sheffield 1808 from the 80's.... Awesome CMM.
We are getting the same problem with the color bar. If we print immediately the bar is on the report. but if we save to excel and look at the report later, it's gone. Good to hear this will be fixed soon, this has the potential to upset our customers